D-Link xStack DES-3528 Series Cli Reference Manual page 253

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
create 802.1x guest_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a previously created VLAN as a 802.1X Guest VLAN for the Switch.
DES-3528:admin# create 802.1x guest_vlan Trinity
Command: create 802.1x guest_vlan Trinity
Success.
DES-3528:admin#
config 802.1x guest_vlan ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the ports for a previously created 802.1X Guest VLAN as enabled.
DES-3528:admin# config 802.1x guest_vlan ports 1-5 state enable
Command: config 802.1x guest_vlan ports 1-5 state enable
Success.
DES-3528:admin#
Used to configure a pre-existing VLAN as an 802.1X Guest VLAN.
create 802.1x guest_vlan <vlan_name 32>
This command is used to configure a pre-defined VLAN as a 802.1X Guest VLAN. 802.1X
Guest VLAN clients are those who have not been authorized for 802.1X or they haven't yet
installed the necessary 802.1X software, yet would still like limited access rights on the
Switch.
<vlan_name 32> − Enter an alphanumeric string of no more than 32 characters to define a
pre-existing VLAN as a 802.1X Guest VLAN. This VLAN must have first been created with
the create vlan command mentioned earlier in this manual.
Only Administrator and Operator-level users can issue this command.
This VLAN must have already been previously created using the create vlan command.
Only one VLAN can be set as the 802.1X Guest VLAN
Used to configure ports for a pre-existing 802.1X guest VLAN.
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
This command is used to configure ports to be enabled or disabled for the 802.1X guest
VLAN.
<portlist> − Specifies a port or range of ports to be configured for the 802.1X Guest VLAN.
all – Specifies this parameter to configure all ports for the 802.1X Guest VLAN.
state [enable | disable] – Use these parameters to enable or disable port listed here as
enabled or disabled for the 802.1X Guest VLAN.
Only Administrator and Operator-level users can issue this command.
This VLAN must have already been previously created using the create vlan command. If
the specific port state changes from an enabled state to a disabled state, these ports will
return to the original VLAN.
253