D-Link xStack DES-3528 Series Cli Reference Manual page 497

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
cfm linktrace
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a cfm linktrace:
DES-3528:admin# cfm linktrace 00-01-02-03-04-05 mep mep1
Command: cfm linktrace 00-01-02-03-04-05 mep mep1
Transaction ID: 26
Success.
DES-3528:admin#
show cfm linktrace
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the cfm linktrace:
Used to transmit a CFM linktrack message.
cfm linktrace <macaddr> [mepname <string 32> | mepid <int 1-8191> md <string 22>
ma <string 22>] {ttl <int 2-255> | pdu_priority <int 0-7>}
This command is used to issue a CFM linktrack message.
<macaddr> – Specifies the destination MAC address.
mepname – Specifies the MEP name.
mepid – Specifies the MEP MEPID.
md – Specifies the maintenance domain name.
ma – Specifies the maintenance association name.
ttl – Specifies the linktrace message TTL value. The default value is 64.
pdu_priority – The 802.1p priority to be set in the transmitted LTM. If not specified, it uses the
same priority as CCMs sent by the MA.
None.
Used to show linktrace responses.
show cfm linktrace [mepname <string 32> | mepid <int 1-8191> md <string 22> ma
<string 22>] {trans_id <uint>}
The maximum linktrace responses a device can hold is 64.
mepname – Specifies the MEP name.
mepid – Specifies the MEP MEPID.
md – Specifies the maintenance domain name.
ma – Specifies the maintenance association name.
trans_id – Specifies the identifier of the transaction to show.
None.
497