xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
DHCPv6 Relay Commands
The DHCPv6 Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config dhcpv6_relay hop_count
config dhcpv6_relay
config dhcpv6_relay ipif
enable dhcpv6_relay
disable dhcpv6_relay
show dhcpv6_relay
debug dhcpv6_relay state
debug dhcpv6_relay output
debug dhcpv6_relay packet
debug dhcpv6_relay hop_count
state
Each command is listed, in detail, in the following sections.
config dhcpv6_relay hop_count
Purpose
Configure the DHCPv6 relay hop_count of the Switch.
Syntax
config dhcpv6_relay hop_count <value 1-32>
Description
Configure the DHCPv6 relay hop_count of the Switch.
Parameters
hop_count - Specifies the number of relay agents that have relayed this message. The
default value is 4.
<value 1-32> - Enter the hop count number here. This value must be between 1 and 32.
Restrictions
Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To configure the maximum hops of a DHCPv6 relay packet could be transferred to 4:
DES-3528:admin#
Command: config dhcpv6_relay hop_count 4
Success.
DES-3528:admin#
Parameters
<value 1-32>
[add | delete] ipif <ipif_name 12> <ipv6addr>
[<ipif_name 12> | all] state [enable | disable]
{ipif <ipif_name 12>}
[enable | disable]
[buffer | console]
{all | receiving | sending} state [enable | disable]
[enable | disable]
config dhcpv6_relay hop_count 4
527