Policy Route Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide

Policy Route Commands

The Policy Route commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
create policy_route name
config policy_route name
delete policy_route name
show policy_route
Each command is listed, in detail, in the following sections.
create policy_route name
Purpose
Used to add policy route rule.
Syntax create policy_route name <policyroute_name 32>
Description This command allows you to create policy route and define this rule name.
Parameters <policyroute_name 32> – Specifies the name of police rule. Max length is 32 character.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To create a policy route:
DES-3528:admin#
Command: create policy_route name engineer
Success.
DES-3528:admin#
Parameters
<policyroute_name 32>
<policyroute_name 32>acl profile_id <value 1-14> access_id <value 1-128>
nexthop <ipaddr> state [enable | disable]
<policyroute_name 32>
•
The ACL rule that is linked to the policy route command could not be deleted via ACL
command.
create policy_route name engineer
454