D-Link xStack DES-3528 Series Cli Reference Manual page 289

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
Success
DES-3528:admin#
To configure the DHCP filter state:
DES-3528:admin# config filter dhcp_server ports 1-10 state enable
Command: config filter dhcp_server ports 1-10 state enable
Success
DES-3528:admin#
show filter dhcp_server
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the DHCP server filter list created on the Switch:
DES-3528:admin#show filter dhcp_server
Command: show filter dhcp_server
Enabled Ports:
Trap & Log State: Disabled
Illegal Server Log Suppress Duration:5 minutes
Filter DHCP Server/Client Table
Server IP Address Client MAC Address
----------------- ------------------
10.255.255.254
Total Entries: 1
DES-3528:admin#
config filter netbios
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the NetBIOS state:
Used to display current DHCP server/client filter list created on the Switch.
Show filter dhcp_server
This command is used to display DHCP server/client filter list created on the Switch.
None.
None.
00-00-00-00-00-01
Used to configure the Switch to filter NetBIOS packets from specified ports.
config filter netbios [<portlist> | all] state [enable | disable]
This command will configure the Switch to filter NetBIOS packets from the specified ports.
<portlist> – The list of port numbers to which the NetBIOS filter will be applied.
state [enable | disable] – Used to enable/disable the NetBIOS filter on the Switch.
Only Administrator-level users can issue this command.
Enabling the NetBIOS filter will create one access profile and three access rules per port
(UDP port number 137 and 138, and TCP port 139).
Port
--------------------
1-28
289