D-Link xStack DES-3528 Series Cli Reference Manual page 128

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
config port_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information:
DES-3528:admin# config port_vlan 1-4 gvrp_state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config gvrp 1-4 state enable ingress_checking enable acceptable_frame
tagged_only pvid 2
Success.
DES-3528:admin#
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the GARP VLAN Registration Protocol (GVRP):
DES-3528:admin# enable gvrp
Command: enable gvrp
Success.
DES-3528:admin#
Used to set the ingress checking status, and the sending and receiving GVRP information.
config port_vlan [<portlist> | all] { gvrp_state [enable | disable] | ingress_checking
[enable | disable] | acceptable_frame[tagged_only | admit_all]pvid<vlanid 1-4094>}(1)
This command is used to configure the Group VLAN Registration Protocol on the Switch.
Ingress checking, the sending and receiving of GVRP information, and the Port VLAN ID
(PVID) can be configured.
<portlist> − A port or range of ports for which users want to enable GVRP for.
all − Specifies all of the ports on the Switch.
gvrp_state [enable | disable] − Enables or disables GVRP for the ports specified in the port
list.
ingress_checking [enable | disable] − Enables or disables ingress checking for the specified
port list.
acceptable_frame [tagged_only | admit_all] – This parameter states the frame type that will
be accepted by the Switch for this function. tagged_only implies that only VLAN tagged
frames will be accepted, while admit_all implies tagged and untagged frames will be
accepted by the Switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with the port.
Only Administrator and Operator users can issue this command.
Used to enable the GARP VLAN Registration Protocol (GVRP).
enable gvrp
This command, along with disable gvrp below, is used to enable and disable GVRP on the
Switch, without changing the GVRP configuration on the Switch.
None.
Only Administrator and Operator and Power-User-level users can issue this command.
128