Time And Sntp Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide

Time and SNTP Commands

The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands in the
Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config sntp
config sntp
ipv6server
show sntp
enable sntp
disable sntp
config time
config time_zone
config dst
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNTP settings:
DES-3528:admin# config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DES-3528:admin#
Parameters
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}(1)
{primary <ipv6addr> | secondary <ipv6addr>}
<date ddmmmyyyy > <time hh:mm:ss >
{operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-4,last> | e_day
<end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 |
90 | 120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> |
offset [30 | 60 | 90 | 120]}]
Used to setup SNTP service.
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}(1)
This command is used to configure SNTP service from an SNTP server. SNTP must be
enabled for this command to function (See enable sntp).
primary − This is the primary server from which the SNTP information will be taken.
<ipaddr> − The IP address of the primary server.
secondary − This is the secondary server the SNTP information will be taken from in the
event the primary server is unavailable.
<ipaddr> − The IP address for the secondary server.
poll-interval <int 30-99999> − This is the interval between requests for updated SNTP
information. The polling interval ranges from 30 to 99,999 seconds.
Only Administrator and Operator-level users can issue this command. SNTP service must be
enabled for this command to function (enable sntp).
309