D-Link xStack DES-3528 Series Cli Reference Manual page 85

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
config system_severity
Purposez
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the system severity settings:
DES-3528:admin#
Command: config system_severity trap critical
Success.
DES-3528:admin#
show system_severity
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the system severity settings for critical traps and log:
DES-3528:admin# show system_severity
Command: show system_severity
Used to configure system_severity level of an alert required for log entry or trap message.
config system_severity [trap | log | all] [emergency | alert | critical | error | warning |
notice | information | debug | <level 0-7>]
This command is used to configure the system_severity levels on the Switch. When an event
occurs on the Switch, a message will be sent to the SNMP agent (trap), the Switch's log or
both. Events occurring on the Switch are separated into eight main categories, these
categories are NOT precisely the same as the parameters of the same name (see below).
Severity Level
Emergency
Alert
Critical
Error
Warning
Notice
Information
Debug
trap - Specifies the severity level control for traps.
log - Specifies the severity level control for the log.
all - Specifies the severity level control for traps and the log.
emergency - Severity level 0.
alert - Severity level 1.
critical - Severity level 2.
error - Severity level 3.
warning - Severity level 4.
notice - Severity level 5.
information - Severity level 6.
debug - Severity level 7.
<level 0-7> - Enter the severity level here. This value must be between 0 and 7.
Only Administrator and Operator-level users can issue this command.
config system_severity trap critical
Used to display system_severity level of an alert required for log entry or trap message.
show system_severity
This command is used to display system_severity level of an alert required for log entry or
trap message.
None.
None.
Description
0 System is unusable.
1 Action must be taken immediately.
2 Critical conditions.
3 Error conditions.
4 Warning conditions.
5 Normal but significant condition.
6 Information messages.
7 Debug-level messages.
85