D-Link xStack DES-3528 Series Cli Reference Manual page 377

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
config jwac switch_http_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure JWAC Switch_http_port:
DES-3528:admin# config jwac switch_http_port 8888 http
Command: config jwac switch_http_port 8888 http
Success.
DES-3528:admin#
Used to configure the TCP port which the JWAC Switch listens to.
config jwac switch_http_port < tcp_port_number 1-65535> {[http | https]}
This command allows you to configure the TCP port which the JWAC Switch listens to. This
port number is used in the second stage of the authentication. PC user will connect the page
on the Switch to input the user name and password.
If not specified, the default port number is 80.
If no protocol is specified, the protocol is HTTP.
< tcp_port_number 1-65535> − A TCP port which the JWAC Switch listens to and uses to
finish the authenticating process.
http − To specify the JWAC runs HTTP protocol on this TCP port
https − To specify the JWAC runs HTTPS protocol on this TCP port
The HTTP cannot run at TCP port 443, and the HTTPS cannot run at TCP port 80.
Only Administrator and Operator and Power-User-level users can issue this command.
377