D-Link xStack DES-3528 Series Cli Reference Manual page 152

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
delete link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete link aggregation group:
DES-3528:admin# delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DES-3528:admin#
config link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 with group members ports 5-7 plus port 9:
DES-3528:admin# config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Command: config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Success.
DES-3528:admin#
Used to delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-8>
This command is used to delete a previously configured link aggregation group.
<value 1-8> − Specifies the group ID. The Switch allows up to eight link aggregation groups
to be configured. The group number identifies each of the groups.
Only Administrator and Operator and Power-User-level users can issue this command.
Used to configure a previously created link aggregation group.
config link_aggregation group_id <value 1-8> {master_port <port> | ports <portlist> |
state [enable | disable] }(1)
This command allows users to configure a link aggregation group that was created with the
create link_aggregation command above.
group _id <value 1-8> − Specifies the group ID. The Switch allows up to 8 link aggregation
groups to be configured. The group number identifies each of the groups.
master_port <port> − Master port ID. Specifies which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link aggregation group will
share the port configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the link aggregation
group.
state [enable | disable] − Allows users to enable or disable the specified link aggregation
group.
Only Administrator and Operator and Power-User-level users can issue this command.
152