D-Link xStack DES-3528 Series Cli Reference Manual page 29

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
config greeting _message
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To modify the banner:
DES-3528:admin#config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
Copyright(C) 2013 D-Link Corporation. All rights reserved.
================================================================================
<Function Key>
Ctrl+C Quit without save
Ctrl+W Save and quit
--------------------------------------------------------------------------------
Used to configure the login banner (greeting message).
config greeting _message {default}
This command is used to modify the login banner (greeting message).
default – If the user enters default to the modify banner command, then the banner will be
reset to the original factory banner.
To open the Banner Editor, click enter after typing the config greeting_message command.
Type the information to be displayed on the banner by using the commands described on the
Banner Editor:
Quit without save:
Save and quit:
Move cursor:
Delete line:
Erase all setting:
Reload original setting:
Only Administrator and Operator-level users can issue this command. Other restrictions
include:
•
If the "reset" command is executed, the modified banner will remain modified.
However, the "reset config/reset system" command will reset the modified banner
to the original factory banner.
•
The capacity of the banner is 6*80. 6 Lines and 80 characters per line.
•
Ctrl+W will only save the modified banner in the DRAM. Users need to type the
"save" command to save it into FLASH.
•
Only valid in threshold level.
DES-3528 Fast Ethernet Switch
Command Line Interface
Firmware: Build 3.00.012
Ctrl+C
Ctrl+W
Left/Right/Up/Down
Ctrl+D
Ctrl+X
Ctrl+L
<Control Key>
left/right/
up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
29