D-Link xStack DES-3528 Series Cli Reference Manual page 496

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
show cfm port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display cfm ports:
DES-3528:admin# show cfm port 1
Command: show cfm port 1
MAC Address: 10:10:90:08:80:12
MD Name MA Name
----------- ----------- ----- ----- --------- ----
op_domain op1
cust_domain cust1
serv_domain serv2
DES-3528:admin#
show cfm mipccm
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the MIPCCM database entries:
DES-3528:admin# show cfm mipccm
Command: show cfm mipccm
MA VID
---------- ----
opma 1
opma 1
Total: 2
DES-3528:admin#
Used to show MEPs and MIPs created on a port.
show cfm port <port> {level <int 0-7> | direction [inward | outward] | vlanid <vlanid 1-
4094>}
This command is used to show MEPs and MIPs created on a port.
port – Specifies the port number.
level – Specifies the MD Level. If not specified, all levels are shown.
direction – Specifies the MEP direction.
inward – Inward facing MEP.
outward – Outward facing MEP.
If not specified, both directions and MIPs are shown.
vlanid – Specifies the VLAN identifier. If not specified, all VLANs are shown.
None.
MEPID Level Direction VID
1 2
8 4
MIP 3
Used to show MIPCCM database entries.
show cfm mipccm
All entries in the MIPCCM database will be shown. The MIPCCM entry is similar to FDB
which keeps the forwarding port information for a MAC entry.
None.
None.
MAC Address
-----------------
00-01-02-03-04-05
00-01-02-03-04-05
inward 2
inward 2
2
Port
-----
2
3
496