Sflow Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide

sFlow Commands

The sFlow commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
enable sflow
disable sflow
show sflow
create sflow flow_sampler
ports
config sflow flow_sampler
ports
delete sflow flow_sampler
ports
show sflow flow_sampler
create sflow counter_poller
ports
config sflow counter_poller
ports
delete sflow counter_poller
ports
show sflow counter_poller
create sflow analyzer_server
config sflow analyzer_server
delete sflow analyzer_server
show sflow analyzer_server
Each command is listed, in detail, in the following sections.
enable sflow
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable sflow:
DES-3528:admin# enable sflow
Command: enable sflow
Success.
DES-3528:admin#
Parameters
[<portlist> | all] analyzer_server_id <value 1-4> {rate <value 0-65535> |
maxheadersize <value 18-256>}
[<portlist> | all] {rate <value 0-65535> | maxheadersize <value 18-256>}
[<portlist> | all]
[<portlist> | all] analyzer_server_id <value 1-4> {interval [disable | <sec 20-120>]}
[<portlist> | all] interval [disable | <sec 20-120>]
[<portlist> | all]
< value 1-4 > owner<name 16> { timeout [<sec 1-2000000> | infinite] |
collectoraddress <ipaddr> | collectorport <udp_port_number 1-65535> |
maxdatagramsize < value 300-1400> }
< value 1-4 > { timeout [<sec 1-2000000> | infinite] | collectoraddress <ipaddr> |
collectorport <udp_port_number 1-65535> | maxdatagramsize < value 300-
1400> }(1)
< value 1-4 >
Used to enable the sFlow function.
enable sflow
This command enables the sFlow function.
None.
Only Administrator and Operator-level users can issue this command.
301