Trademarks; Cautions And Warnings; Electrical Safety And Compliance; Fuses - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Preface

Trademarks

Product names mentioned in this manual may be trademarks or registered trademarks of their
respective companies and are hereby acknowledged.
The user should carefully observe the following information:
IMPORTANT

Cautions and Warnings

IMPORTANT or NOTE indicates a statement associated with the task being
performed or information critical for proper equipment function.
IMPORTANT
CAUTION indicates a hazardous situation that, if not avoided, may result in
minor or moderate injury. CAUTION may also be used to indicate other unsafe
practices or risks of property damage.
CAUTION
WARNING indicates a potentially hazardous situation that, if not avoided, could
result in death or serious injury.
WARNING

Electrical Safety and Compliance

The CDM-710 has been shown to comply with the EN 60950 Safety of Information
Technology Equipment (Including Electrical Business Machines) safety standard.
The equipment is rated for operation over the range 100 to 240 VAC. It has a maximum power
consumption of 60 watts, and draws a maximum of 600 mA.

Fuses

FOR CONTINUED OPERATOR SAFETY, ALWAYS REPLACE THE FUSES WITH
THE CORRECT TYPE AND RATING.
CAUTION
The CDM-710 is fitted with two fuses - one each for line and neutral connections. These are
contained within the body of the IEC power inlet connector, behind a small plastic flap.
•
For 115 and 230 volt AC operation, use T2.00A, 20mm fuses.
•
For 48 VDC operation, use T6.25A, 6.3x32mm fuses.

Low Voltage Directive (LVD)

The following information is applicable for the European Low Voltage Directive (2006/95/EC):
xiv
Revision 11
MN/CDM710.IOM