Menu Matrix - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation
5.2.1

Menu Matrix

Sect. Description
5.2 Opening Screen
5.3 Select (Main) Menu
5.3.1 Configuration
5.3.1.1 (CONFIG:) Remote Control
0 (CONFIG:) Tx
5.3.1.3 (CONFIG:) Rx
5.3.1.4 (CONFIG:) Intfc1 (CDI-40 ASI Interface only)
5.3.1.5 (CONFIG:) Intfc1 (CDI-60 HSSI Interface only)
(CONFIG:) Intfc2 (CDI-70 Gigabit Ethernet
5.3.1.6
Interface only)
5.3.1.7 (CONFIG:) Ref
5.3.1.8 (CONFIG:) Aux
5.3.1.9 (CONFIG:) Alarms
5.3.2 Monitor
5.3.2.1 (Monitor:) Alarms
5.3.2.2 (Monitor:) Rx Stats
5.3.2.3 (Monitor:) Event-Log
5.3.3 Test
5.3.4 Info
5.3.5 Save/Load
5.3.5.1 (Save/Load:) Save
5.3.5.2 (Save/Load:) Load
5.3.6 Utility
5.3.6.1 (Utility:) RT-Clk
5.3.6.2 (Utility:) Ref
5.3.6.3 (Utility:) ID
5.3.6.4 (Utility:) Display
5.3.6.5 (Utility:) Firmware
5.3.6.6 (Utility:) FAST
Notes:
1. The CONFIG: Tx
Modulator card is installed.
2. Refer to CONFIG: Tx
3. The following CONFIG: submenus are available only when the Mode selection is DVB-S2:
Tx Scram; Tx
Dem Scr.
Remarks
Select: Config; Monitor; Test; Info; Save/Load; Util
Select: Remote; Tx; Rx: Int1; Int2; Ref; Aux; Alarms
Select: Local; Serial; Ethernet; Ser+Eth
Select: FEC; Mod; Code; SymRate; Mode; Freq; Pwr; Scram
Select: FEC; Dem; Code; SymRate; Mode; Freq; Eb/No; PLL
Select: Tx; Rx; Config
Select: Tx; Rx; CTS/RTS
Select: Ingress; Egress; Man; Stats
Select: Ena/Dis; Force (1:1)
Select: Tx; Intfc1; Intfc2
Select: Alarms; Rx Stats; Event-Log
Select: Transmit; Receive; Unit
Select: View; Clear-All
Select: Mode; TestPatterns
Select: Rem; Tx; Rx; Intfc1; Intfc2
Select: Save; Load
Select: RT-CLK; Ref; ID; Display; Firmware; FAST
Select: Info; Select
Select: Cnfg; View
Pwr Imp (Impedance) selection appears only when the 70/140 MHz
SymRate for the Data Rate table.
Mod Pilot; Tx Mod
5–5
Frame; Rx Dem
Revision 11
MN/CDM710.IOM
Pilot; and Rx