Config:) Int2 (Cdi-70 Gigabit Ethernet Interface Only); (Config: Intfc2 Gigabit Ethernet) Ingress; (Config: Intfc2 Gigabit Ethernet) Ingress Ena/Dis; (Config: Intfc2 Gigabit Ethernet) Ingress Fec - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation
5.3.1.6

(CONFIG:) Int2 (CDI-70 Gigabit Ethernet Interface Only)

Due to limitations of the backplane, the CDM-710 allows only one interface to
be active. For example, if Interface 1 is active, and Interface 2 is then 'enable
selected', the unit will automatically disable Interface 2.
IMPORTANT
Note: The CDM-710 supports a single CDI-70 Gigabit Ethernet Interface (Intfc2), installable in
Slot 2 only; there is a single RJ-45 port on the CDI-70 Gigabit Ethernet Interface. The menu
branch and submenus depicted in this section show what is available when the CDI-70 Gigabit
Ethernet Interface card is installed in Interface Slot 2.
Intfc2 Gigabit Ethernet:
Ingress Egress Man Stats
Select Ingress, Egress, Man, or Stats using the
Note, for the purpose of the documentation of this interface, the following:
•
Ingress refers to IP packets received from the LAN
•
Egress refers to IP packets transmitted to the LAN
•
Transmit refers to MPEG packets transmitted to the WAN
•
Receive refers to MPEG packets received from the WAN

(CONFIG: Intfc2 Gigabit Ethernet) Ingress

Intfc2 Gigabit Ingress:
Ena/Dis FEC Str
Select Ena/Dis, FEC, or Str using the ◄ ► arrow keys, then press
(CONFIG: Intfc2 Gigabit Ethernet) Ingress
Intfc2 Ingress Enable:
Enable Disable
Select Enable or Disable using the ◄ ► arrow keys, then press
transmission of the ingress (received from LAN) MPEG-2 transmission stream. Disable is
selected to turn off the MPEG-2 transmission to the WAN.
(CONFIG: Intfc2 Gigabit Ethernet) Ingress
Intfc2 Ingress FEC
Enable Disable
Select Enable or Disable using the ◄ ► arrow keys, then press
to perform SMPTE 2022 / Pro-MPEG COP3 error recovery. Disable is selected to bypass
the SMPTE 2022 / Pro-MPEG COP3 function.
Note: SMPTE absorbed the per-MPEG Forum and released SMTE 2022.
arrow keys, then press
( E)
5–30
MN/CDM710.IOM
.
ENTER
.
ENTER
Ena/Dis
. Enable is selected for
ENTER
FEC
. Enable for the GbEI
ENTER
Revision 11