Comtech EF Data CDM-710 Installation And Operation Manual page 6

Errata A for MN/CDM710.IOM Rev 11
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier) Query
Faults and
Status (cont.)
ER-CDM710-EA11
Description of Arguments
C= Reserved
D= ASI Port Transmit Data Loss (Interface 1)
E= Reserved
F= ASI Frame Not Synchronized (Interface 1)
G= Reserved
H= HSSI TX Clock Failure (Interface 1)
I= Reserved
J= GBEI Card Datarate > + 200 PPM
K= GBEI Card Datarate < - 200 PPM
L= GBEI No PHY Link
M= Encoder FIFO Empty
N= Encoder FIFO Full
O= ASI Tx Input Datarate Offset > +110PPM (Interface 1)
P= Reserved
Q= ASI Tx Input Datarate Offset < -110PPM (Interface 1)
R= Reserved
S= SERDES Parity Errors
c=Rx Traffic Status
0=No faults
d=New Faults
0=No new faults
1=New faults since last check
e=Configuration change
0=Modem configuration has not been changed
1= Modem configuration has been changed
THIS DOCUMENT IS NOT SUBJECT TO REVISION/UPDATE! PLM CO C-0025029
Response to
Update 'FLT' Serial Remote Control Query
Query
(Instruction
Response to Query
Command Code and
Qualifier)
Page 4 of 4