Config:) Int1 (Cdi-60 Hssi Interface Only); (Config: Intfc1 Hssi) Tx; (Config: Intfc1 Hssi) Tx Data; (Config: Intfc1 Hssi) Tx Data Datarate - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation
5.3.1.5

(CONFIG:) Int1 (CDI-60 HSSI Interface Only)

Due to limitations of the backplane,
be active. For example, if Interface 2 is active, and Interface 1 is then enabled/
selected, the unit will automatically
IMPORTANT
Note: The menu branch and submenus depicted in this section are dependent on the presence
of the CDI-60 HSSI Interface card, installable in Interface Slot 1 only.
Intfc1
Tx Rx CTS/RTS
There is a single port on a CDI-60 HSSI Interface. Select Tx, Rx, or CTS/RTS using the
arrow keys, then press

(CONFIG: Intfc1 HSSI) Tx

Intfc1
Data Clock
Select Data, Clock, or Enable using the
(CONFIG: Intfc1 HSSI) Tx
Intfc1
Datarate
Select Datarate or Invert using the
(CONFIG: Intfc1 HSSI) Tx
Intfc1
Tx: 032.000000 Mbps
This screen is 'status only' and indicates the Data Rate of the transmit MPEG-2 transport
stream. Press
(CONFIG: Intfc1 HSSI) Tx
Intfc1
Normal Inverted
To control data inversion (added for compatibility with certain older equipment), select
Normal or Inverted using the
HSSI:
(
.
ENTER
Tx
Enable (
Tx Data:
Invert
Data Rate:
or
ENTER CLEAR
Tx Data Invert:
the CDM-710 allows only one interface to
disable Interface 2.
E)
E)
arrow keys, then press
Data
( E)
arrow keys, then press
Data Datarate
to return to the previous menu.
Data Invert
( E)
arrow keys, then press
5–26
Revision 11
MN/CDM710.IOM
.
ENTER
.
ENTER
.
ENTER