(Config: Intfc1 Hssi) Rx Clock Invert; (Config: Intfc1 Hssi) Rx Enable; (Config: Intfc1 Hssi) Rts/Cts - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation
(CONFIG: Intfc1 HSSI) Rx
Intfc1 Rx Clock Invert:
Normal
This selection controls clock inversion (added for compatibility with certain older
equipment). Select Normal or Inverted using the
(CONFIG: Intfc1 HSSI) Rx
Intfc1 Rx Enable:
Enable Disable
Using the
Disable to de-activate the Rx side and set the Data Rate to 0. Press

(CONFIG: Intfc1 HSSI) RTS/CTS

Intfc1 CTS/RTS:
Normal
Select Normal or Fault using the
Note: CTS is the same as CA, and RTS is the same as TA. The selections operate as follows:
• Normal: CTS = RTS
•
Fault: CTS = RTS when no fault is present. CTS is not asserted when a fault is present.
Inverted
arrow keys, select Enable to activate the Rx side of this interface, or select
Fault
Clock Invert
( E)
Enable
( E)
arrow keys, then press
ENTER
5–29
MN/CDM710.IOM
arrow keys, then press
ENTER
when done.
ENTER
.
Revision 11
.