Config:) Int1 (Cdi-40 Asi Interface Only); (Config: Intfc1 Asi) Tx; (Config: Intfc1 Asi) Tx Ena/Dis; (Config: Intfc1 Asi) Tx Frame - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation
5.3.1.4

(CONFIG:) Int1 (CDI-40 ASI Interface Only)

Due to limitations of the backplane,
be active. For example, if Interface 2 is active, and Interface 1 is then enabled/
selected, the unit will automatically
IMPORTANT
Note: The menu branch and submenus depicted in this section are dependent on the presence
of the CDI-40 ASI Interface card, installable in Interface Slot 1 only.
Intfc1 ASI:
Tx Rx
Select Tx, Rx, or Config using the

(CONFIG: Intfc1 ASI) Tx

Intfc1 ASI Tx:
Ena/Dis
Select Ena/Dis or Frame using the
(CONFIG: Intfc1 ASI) Tx
Intfc1 ASI Tx:
Enable Disable
Using the
Disable to de-activate the Tx side and set the Data Rate to 0. Press
(CONFIG: Intfc1 ASI) Tx
Intfc1 ASI Tx Frame:
188
To enable the desired sync mode, select 108 or 204 using the ◄ ► arrow keys, then press
.
ENTER

(CONFIG: Intfc1 ASI) Rx

Intfc1 ASI Rx:
Ena/Dis
Select Ena/Dis or Frame using the
(CONFIG: Intfc1 ASI) Rx
Intfc1 ASI Rx:
Enable Disable
Using the
Disable to de-activate the Rx side and set the Data Rate to 0. Press
Config (
Frame (
(
arrow keys, select Enable to activate the Tx side of this interface, or select
204 ( E)
Frame (
(
arrow keys, select Enable to activate the Rx side of this interface, or select
the CDM-710 allows only one interface to
disable Interface 2.
E)
arrow keys, then press
ENTER
E)
arrow keys, then press
Ena/Dis
E)
Frame
E)
arrow keys, then press
Ena/Dis
E)
5–24
Revision 11
MN/CDM710.IOM
.
.
ENTER
when done.
ENTER
.
ENTER
when done.
ENTER