Comtech EF Data CDM-710 Installation And Operation Manual page 203

Broadcast satellite modem
Table of Contents

Advertisement

CDM-710 Broadcast Satellite Modem
Appendix A
Command
Arguments for
Parameter
(Instruction
Command or
Type
Code and
Response to
Qualifier)
Query
Redundancy
RED=
1 byte
State
Rx Frequency
N/A
5 bytes
Offset
Rx Frequency
RFQ=
9 bytes
Rx Frame Size
N/A
1 byte
Rx FEC Type
N/A
1 byte
Rx Gold Code
RGS=
6 bytes
Sequence
Index
Description of Arguments
Command or Query.
Unit returns the redundancy state of the unit in the form x, where:
0 = Offline
1 = Online
Notes:
1. This command can be used to force the unit offline, this is done by sending
RED=0. This is only valid if redundancy mode is enabled – if redundancy is not
enabled, then RED=0 will return an error. The unit cannot be forced online.
2. If the unit is not in redundancy mode, then the unit will always be online.
Example: RED=0 (force unit offline)
Query only.
Unit returns the value of the measured frequency offset of the carrier being
demodulated in the form sxxx.x. Values range from ± 0 to ± 100 kHz, 100 Hz
resolution.
Returns 999999 if the demodulator is unlocked.
Example: RFO=+002.3 (which is + 2.3 kHz)
Command or Query.
Rx Frequency (in MHz) in the form xxxx.xxxx:
52 to 88 MHz, and 104 to 176 MHz (70/140 Modulator)
950 to 1950 MHz (L-Band Modulator)
Resolution=100Hz.
Example: RFQ=0950.0000
Query only.
Rx Frame Size Long/Short selection in the form x, where:
0=Short,
1=Long
Example: RFS =0 (which is Short Frame Size)
Note: Valid only in DVB-S2 mode. If the unit is not locked, the query returns 'x'.
Query only.
Rx FEC coding type in the form x, where:
0=Viterbi + Reed-Solomon
1=LDPC
Note: FEC is dependent on the RX Mode Type.
Example: RFT=1 (which is LDPC coding)
Command or Query.
Rx Gold Code Sequence Index:
xxxxxx = Gold Code Sequence index ( 0 to 262141 )
Example: RGS=189063
Note: Valid only in DVB-S2 mode.
A–29
MN/CDM710.IOM
Query
Response to
(Instruction
Response to Query
Command
Code and
Qualifier)
RED=
RED?
RED=x
RED?
(See Description of
RED*
Arguments)
RED#
RFO?
RFO?
RFO=sxxx.x
RFO*
RFO#
RFQ=
RFQ?
RFQ=xxxx.xxxx
RFQ?
RFQ*
RFQ#
RFS?
RFS?
RFS =x
RFS *
RFS #
RFT?
RFT?
RFT=x
RFT*
RFT#
RGS=
RGS?
RGS=xxxxxx
RGS?
RGS*
RGS#
Revision 11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CDM-710 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Cdm-710l

Table of Contents