Working With Dms-100 Switches - AudioCodes Mediant 2000 User Manual

To define an explicit Interface ID for a T1 trunk (that is different from the default), use the
following parameters:

ISDNIBehavior_x = 512 (x = 0 to the maximum number of trunks identifying the
device's physical trunk)

ISDNNFASInterfaceID_x = ID (x = 0 to 255)
Notes:

11.4.2 Working with DMS-100 Switches

The DMS-100 switch requires the following NFAS Interface ID definitions:

InterfaceID #0 for the Primary trunk

InterfaceID #1 for the Backup trunk

InterfaceID #2 for a 24 B-channel T1 trunk

InterfaceID #3 for a 24 B-channel T1 trunk, and so on for subsequent T1 trunks
For example, if four T1 trunks on a device are configured as a single NFAS group with
Primary and Backup T1 trunks that is used with a DMS-100 switch, the following
parameters should be used:
NFASGroupNumber_0 = 1
NFASGroupNumber_1 = 1
NFASGroupNumber_2 = 1
NFASGroupNumber_3 = 1
DchConfig_0 = 0
DchConfig_1 = 1
DchConfig_2 = 2
DchConfig_3 = 2
If there is no NFAS Backup trunk, the following configuration should be used:
ISDNNFASInterfaceID_0 = 0
ISDNNFASInterfaceID_1 = 2
ISDNNFASInterfaceID_2 = 3
ISDNNFASInterfaceID_3 = 4
ISDNIBehavior = 512
;ISDNNFASInterfaceID coniguration above
NFASGroupNumber_0 = 1
NFASGroupNumber_1 = 1
NFASGroupNumber_2 = 1
SIP User's Manual
•
Usually the Interface Identifier is included in the Q.931 Setup/Channel
Identification IE only on T1 trunks that doesn't contain the D-channel.
Calls initiated on B-channels of the Primary T1 trunk, by default, don't
contain the Interface Identifier. Setting the parameter ISDNIBehavior_x to
2048' forces the inclusion of the Channel Identifier parameter also for the
Primary trunk.
•
The parameter ISDNNFASInterfaceID_x = ID can define the 'Interface ID'
for any Primary T1 trunk, even if the T1 trunk is not a part of an NFAS
group. However, to include the Interface Identifier in Q.931
Setup/Channel Identification IE configure ISDNIBehavior_x = 2048 in the
ini file.
;Primary T1 trunk
;Backup T1 trunk
;B-Channel NFAS trunk
;B-channel NFAS trunk
;This parameter should be added because of
478
Mediant 2000
Document #: LTRT-68809