AudioCodes Mediant 2000 User Manual page 350

Parameter
Web: Default Destination Number
[DefaultNumber]
Web: Source IP Address Input
[SourceIPAddressInput]
Web: Use Source Number As
Display Name
EMS: Display Name
[UseSourceNumberAsDisplayN
ame]
SIP User's Manual
device's port according to the called number. If the called
number isn't found, it then selects the next available channel
in ascending cyclic order. Note that if the called number is
found, but the port associated with this number is busy, the
call is released.

[6] By Source Phone Number = Selects the device's channel
according to the calling number.

[7] Trunk Cyclic Ascending = Selects the device's port from
the first channel of the next trunk (next to the trunk from
which the previous channel was allocated.
Notes:

The internal numbers of the device's B-channels are defined
by the TrunkGroup parameter.

For defining the channel select mode per
to ''Configuring the Trunk Group Settings''
Defines the default destination phone number used if the
received message doesn't contain a called party number and no
phone number is configured in the '
"Configuring the Trunk Group Table" on page
parameter is used as a starting number for the list of channels
comprising all the device's Trunk
The default value is 1000.
Determines the IP address that the device uses to determine the
source of incoming INVITE messages for IP-to-Tel routing.

[-1] = Auto Decision - if the IP-to-IP feature is enabled, this
parameter is automatically set to Layer 3 Source IP. If the IP-
to-IP feature is disabled, this parameter is automatically set
to SIP Contact Header

[0] SIP Contact Header = Use the IP address in the Contact
header of the incoming INVITE message.

[1] Layer 3 Source IP = Use the actual IP address (Layer 3)
from which the SIP packet was received.
Determines the use of Tel Source Number and Display Name for
Tel-to-IP calls.

[0] No = If a Tel Display Name is received, the Tel Source
Number is used as the IP Source Number and the Tel
Display Name is used as the IP Display Name. If no Display
Name is received from the Tel side, the IP Display Name
remains empty (default).

[1] Yes = If a Tel Display Name is received, the Tel Source
Number is used as the IP Source Number and the Tel
Display Name is used as the IP Display Name. If no Display
Name is received from the Tel side, the Tel Source Number
is used as the IP Source Number and also as the IP Display
Name.

[2] Overwrite = The Tel Source Number is used as the IP
Source Number and also as the IP Display Name (even if the
received Tel Display Name is not empty).
350
Description
Trunk Group, refer
on page
Trunk Group ' table (refer to
155
Groups.
. (default)
Document #: LTRT-68809
Mediant 2000
157 .
). The