AudioCodes Mediant 2000 User Manual page 349

SIP User's Manual
Parameter
Web: Trunk Group Settings Table
EMS: SIP Routing > Hunt Group
[TrunkGroupSettings]
Web: Channel Select Mode
EMS: Channel Selection Mode
[ChannelSelectMode]
Version 5.8
This ini file table parameter defines rules for port allocation per
Trunk Group. If no rule exists, the global rule defined by the
parameter ChannelSelectMode takes effect. The format of this
parameter is as follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,TrunkGroupSettings_Cont
actUser, TrunkGroupSettings_ServingIPGroup
[\TrunkGroupSettings]
For example:
[TrunkGroupSettings]
TrunkGroupSettings 0 = 1, 0, 5, audiocodes, user, 1;
TrunkGroupSettings 1 = 2, 1, 0, localname, user1, 2;
[\TrunkGroupSettings]
Notes:

This parameter can include up to 24

For configuring Trunk Group Settings using the Web
interface, refer to ''Configuring Trunk Group Settings''
page 157 .

For a description on using ini file table parameters, refer to
''Format of ini File Table Parameters''
Port (channel) allocation algorithm for IP-to-Tel calls.

[0] By Dest Phone Number = Selects the device's channel
according to the called number. (default.)

[1] Cyclic Ascending = Selects the next available channel in
an ascending cyclic order. Always selects the next higher
channel number in the Trunk Group. When the device
reaches the highest channel number in the Trunk Group, it
selects the lowest channel number in the Trunk
then starts ascending again.

[2] Ascending = Selects the lowest available channel. It
always starts at the lowest channel number in the Trunk
Group and if that channel is not available, selects the next
higher channel.

[3] Cyclic Descending = Selects the next available channel in
descending cyclic order. Always selects the next lower
channel number in the Trunk Group. When the device
reaches the lowest channel number in the Trunk Group, it
selects the highest channel number in the Trunk
then starts descending again.

[4] Descending = Selects the highest available channel.
Always starts at the highest channel number in the Trunk
Group and if that channel is not available, selects the next
lower channel.

[5] Dest Number + Cyclic Ascending = First selects the
349
6. Configuration Parameters Reference
Description
Index =
0 indices.
on page
;
on
199 .
Group and
Group and
October 2009