AudioCodes Mediant 2000 User Manual page 331

SIP User's Manual
Parameter
Web/EMS: Remove CLI when
Restricted
[RemoveCLIWhenRestricted]
Web/EMS: Remove Calling Name
[RemoveCallingName]
Web: Remove Calling Name
EMS: Remove Calling Name For
Trunk Mode
[RemoveCallingNameForTrunk_I
D]
Web/EMS: Progress Indicator to
ISDN
[ProgressIndicator2ISDN_ID]
Web: Set PI in Rx Disconnect
Message
EMS: Set PI For Disconnect Msg
[PIForDisconnectMsg_ID]
EMS: Connect On Progress Ind
[ConnectOnProgressInd]
Version 5.8
Determines (for IP-to-Tel calls) whether the Calling Number
and Calling Name IEs are removed from the ISDN SETUP
message if the presentation is set to Restricted.

[0] No = IE's are not removed (default).

[1] Yes = IE's are removed.
Enables the device to remove the Calling Name from SIP-to-
ISDN calls for all trunks.

[0] Disable = Does not remove Calling Name (default).

[1] Enable = Removes Calling Name.
Enables the device to remove the Calling Name per trunk
(where ID denotes the trunk number) for SIP-to-ISDN calls.

[-1] Use Global Parameter = Settings of the global
parameter RemoveCallingName are used (default).

[0] Disable = Does not remove Calling Name.

[1] Enable = Remove Calling Name.
Progress Indicator (PI) to ISDN. The
parameter depicts the trunk number, where 0 is the first trunk.

[-1] Not Configured = The PI in ISDN messages is set
according to the parameter PlayRBTone2Tel (default).

[0] No PI = PI is not sent to ISDN.

[1] PI = 1; [8] PI = 8: The PI value is sent to PSTN in
Q.931/Proceeding and Alerting messages. Typically, the
PSTN/PBX cuts through the audio channel without playing
local Ringback tone, enabling the originating party to hear
remote Call Progress Tones or network announcements.
Defines the device's behavior when a Disconnect message is
received from the ISDN before a Connect message is
received. The ID in the ini
number, where 0 is the first trunk.

[-1] Not Configured = Sends a 183 SIP response according
to the received progress indicator (PI) in the ISDN
Disconnect message. If PI = 1 or 8, the device sends a 183
response, enabling the PSTN to play a voice
announcement to the IP side. If there isn't a PI in the
Disconnect message, the call is released (default).

[0] No PI = Doesn't send a 183 response to IP. The call is
released.

[1] PI = 1; [8] PI = 8: Sends a 183 response to IP.
Enables the play of announcements from IP to PSTN without
the need to answer the Tel-to-IP call. It can be used with
PSTN networks that don't support the opening of a TDM
channel before an ISDN Connect message is received.

[0] = Connect message isn't sent after SIP 183 Session
Progress message is received (default).

[1] = Connect message is sent after SIP 183 Session
Progress message is received.
331
6. Configuration Parameters Reference
Description
ID in the ini
file parameter depicts the trunk
file
October 2009