AudioCodes Mediant 2000 User Manual page 328

Parameter
Web: Digital Out-Of-Service
Behavior
EMS: Digital OOS Behavior For
Trunk Value
[DigitalOOSBehaviorFor
Trunk_ID]
Web: Digital Out-Of-Service
Behavior
[DigitalOOSBehavior]
SIP User's Manual
LocalISDNRBSource is set to 1.
Determines the method for setting digital trunks to Out-Of-
Service state per trunk.

[-1] Not Configured = Use the settings of the
DigitalOOSBehavior parameter for per device (default).

[0] Default = Uses default behavior for each trunk (see
note below).

[1] Service = Sends ISDN In or Out of Service (only for
ISDN protocols that support Service message).

[2] D-Channel = Takes D-Channel down or up (ISDN only).

[3] Alarm = Sends or clears PSTN AIS Alarm (ISDN and
CAS).

[4] Block = Blocks trunk (CAS only).
Notes:

This parameter is applicable only if the parameter
EnableBusyOut is set to 1.

The default behavior (value 0) is as follows:

ISDN: Use Service messages on supporting variants
and use Alarm on non-supporting variants.

CAS: Use Alarm.

When updating this parameter value at run-time, you must
stop the trunk and then restart it for the update to take
effect.

To determine the method for setting Out-Of-Service state
for all trunks (i.e., per device), use the DigitalOOSBehavior
parameter.

The ID in the ini file parameter name represents the trunk
number, where 0 is the first trunk.
Determines the method for setting digital trunks to Out-Of-
Service state per device.

[0] Default = Uses default behavior for each trunk - see
note below (default)

[1] Service = Sends ISDN In or Out of Service (only for
ISDN protocols that support Service message).

[2] D-Channel = Takes D-Channel down or up (ISDN only).

[3] Alarm = Sends or clears PSTN AIS Alarm (ISDN and
CAS).

[4] Block = Blocks trunk (CAS only).
Notes:

This parameter is applicable only if the parameter
EnableBusyOut is set to 1.

The default behavior (value 0) is as follows:

ISDN: Use Service messages on supporting variants
and use Alarm on non-supporting variants.

CAS: Use Alarm.

When updating this parameter value at run-time, you must
stop the trunk and then restart it for the update to take
effect.
328
Description
Document #: LTRT-68809
Mediant 2000