AudioCodes Mediant 2000 User Manual page 159

SIP User's Manual
Parameter
Serving IP Group ID
[TrunkGroupSettings_ServingI
PGroup]
Gateway Name
[TrunkGroupSettings_Gateway
Name]
Contact User
[TrunkGroupSettings_Contact
User]
Version 5.8
'Don't Register'.

[5] Per Account = Registrations are sent (or not) to an IP
Group, according to the settings in the Account table (refer to
''Configuring the Account Table''
Notes:

To enable Trunk Group registrations, configure the global
parameter IsRegisterNeeded to 1. This is unnecessary for 'Per
Account' registration mode.

If no mode is selected, the registration is performed according
to the global registration parameter ChannelSelectMode (refer
to '' Configuring Proxy and Registration Parameters''
101 ).

If the device is configured globally (ChannelSelectMode) to
register Per Endpoint, and a Trunk Group comprising four
channels is configured to register Per Gateway, the device
registers all channels except the first four channels. The Trunk
Group of these four channels
request.
The Serving IP Group ID to where INVITE messages initiated by
this Trunk Group's endpoints are sent. The actual destination to
where these INVITE messages are sent is according to the Proxy
Set ID (refer to ''Configuring the Proxy Sets Table''
associated with this Serving IP Group. The Request URI
hostname in the INVITE and REGISTER messages (except for
'Per Account' registration modes) is set to the value of the field
'SIP Group Name' defined in the 'IP Group' table (refer to
''Configuring the IP Groups''
If no Serving IP Group ID is selected, the INVITE messages are
sent to the default Proxy or according to the 'Tel to IP Routing
Table' (refer to ''Configuring the Tel to IP Routing Table''
138 ) or 'Outbound IP Routing Table' if the IP2IP application is
enabled (refer to "Configuring the Outbound IP Routing Table" on
page 142).
Note: If the parameter PreferRouteTable is set to 1 (refer to
''Configuring Proxy and Registration Parameters''
the routing rules in the 'Tel to IP Routing Table' (or 'Outbound IP
Routing Table') prevail over the selected Serving IP Group ID.
The host name used in the SIP From header in INVITE
messages, and as a host name in From/To headers in
REGISTER requests. If not configured, the global parameter
SIPGatewayName is used instead.
The user part in the SIP Contact URI in INVITE messages, and
as a user part in From, To, and Contact headers in REGISTER
requests. This is applicable only if the field 'Registration Mode' is
set to 'Per Account', and the Registration through the Account
table is successful.
Notes:

If registration fails, then the userpart in the INVITE Contact
header contains the source party number.

The 'ContactUser' parameter in the 'Account Table' page
overrides this parameter.
159
3. Web-Based Management
Description
on page 111 ).
sends a single registration
on page 107 ).
on page
on page 103 )
on page
on page 101 ),
October 2009