Timbre Eq; Master Effect 1, Master Effect 2 - Korg RK-100S Parameter Manual

TIMBRE EQ

Here you can adjust the equalizer settings. The equalizer is a shelving type.
LOW FREQ (Low EQ Frequency)
Specifies the frequency of the low equalizer.
LOW GAIN (Low EQ Gain)
Specifies the gain of the low equalizer.
Positive (+) values boost the region below the cutoff frequency.
Negative (–) values cut the region below the cutoff frequency.
HIGH FREQ (High EQ Frequency)
Specifies the cutoff frequency of the high equalizer.
HIGH GAIN (High EQ Gain)
Specifies the gain of the high equalizer.
Positive (+) values boost the region above the cutoff frequency.
Negative (–) values cut the region above the cutoff frequency.

MASTER EFFECT 1, MASTER EFFECT 2

Here you can adjust settings for the master effects. You can choose from seventeen
different types.
FX.TYPE
This selects the effect type used by the master effect. For details on the available
effects, refer to page 37 "Effect guide".
FX LONG RIBBON ( FILTER ) ASSIGN
If an effect parameter is assigned to the "Long Ribbon (Filter)", it can also be
controlled when the filter is controlled with the long ribbon controller.
FX LONG RIBBON ( FILTER ) POLARITY
The polarity direction assigned to the "FX LONG RIBBON (FILTER) ASSIGN"
can be switched.
[0020Hz...1000Hz]
[–15.0dB...+15.0dB]
[1.00 kHz...20.0 kHz]
[–15.0dB...+15.0dB]
[Effect Off...Grain Shifter]
[Assign OFF ... ]
[Forward, Reverse]
PROGRAM
27