Advanced 802.1X Configuration; Configuring Proxy Checking - H3C S3100-52P Manual

Operation Manual – 802.1x and System Guard
H3C S3100-52P Ethernet switch
Note:
As for the dot1x max-user command, if you execute it in system view without
specifying the interface-list argument, the command applies to all ports. You can
also use this command in port view. In this case, this command applies to the
current port only and the interface-list argument is not needed.
As for the configuration of 802.1x timers, the default values are recommended.

1.4 Advanced 802.1x Configuration

Advanced 802.1x configurations, as listed below, are all optional.
Configuration concerning CAMS, including multiple network adapters detecting,
proxy detecting, and so on.
Client version checking configuration
DHCP–triggered authentication
Guest VLAN configuration
802.1x re-authentication configuration
Configuration of the 802.1x re-authentication timer
You need to configure basic 802.1x functions before configuring the above 802.1x
features.

1.4.1 Configuring Proxy Checking

Follow these steps to configure proxy checking:
Enter system view
Enable proxy checking
function globally
Enable proxy
checking for a
port/specified
ports
To do... Use the command...
system-view
dot1x
supp-proxy-check
{ logoff | trap }
dot1x
supp-proxy-check
In system
{ logoff | trap }
view
[ interface
interface-list ]
interface
In port
interface-type
view
interface-number
dot1x
supp-proxy-check
{ logoff | trap }
1-20
Chapter 1 802.1x Configuration
Remarks
—
Required
By default, the 802.1x
proxy checking function is
globally disabled.
Required
By default, the 802.1x
proxy checking is disabled
on a port.