Basic Vlan Interface Configuration - H3C S5600 Series Operation Manual

VLAN 1 is the system default VLAN, which needs not to be created and cannot be removed, either.
The VLAN you created in the way described above is a static VLAN. On the switch, there are
dynamic VLANs which are registered through GVRP. For details, refer to "GVRP" part of this
manual.
When you use the vlan command to create VLANs, if the destination VLAN is an existing dynamic
VLAN, it will be transformed into a static VLAN and the switch will output the prompt information.

Basic VLAN Interface Configuration

Configuration prerequisites
Before configuring a VLAN interface, create the corresponding VLAN.
Configuration procedure
Follow these steps to perform basic VLAN interface configuration:
To do...
Enter system view
Create a VLAN interface
and enter VLAN interface
view
Specify the description
string for the current VLAN
interface
Disable the VLAN interface
Enable the VLAN Interface
Use the command...
system-view
interface Vlan-interface
vlan-id
description text
shutdown
undo shutdown
2-2
Remarks
—
Required
By default, there is no VLAN interface on a
switch.
Optional
By default, the description string of a VLAN
interface is the name of this VLAN interface.
Vlan-interface1 Interface for example.
Optional
By default, the VLAN interface is enabled. In this
case, the VLAN interface's status is determined
by the status of the ports in the VLAN, that is, if
all ports of the VLAN are down, the VLAN
interface is down (disabled); if one or more ports
of the VLAN are up, the VLAN interface is up
(enabled).
If you disable the VLAN interface, the VLAN
interface will always be down, regardless of the
status of the ports in the VLAN.