10. Snmp Server Configuration; Introduction; Configuring And Displaying The Snmp Server Settings - Nokia ESB26 User Manual

10. SNMP Server Configuration

Introduction

SNMP (Simple Network Management Protocol) is the Network management protocol that is
used almost exclusively in TCP/IP networks. The Nokia ESB26 switch is fully manageable
via SNMP.

Configuring and Displaying the SNMP Server Settings

SNMP Configuration Commands
In order to activate the SNMP agent and make a communication inside the SNMP entity
(from the manager to the agent), proceed according to the following guidelines:
1. Change the SNMP engine-ID if the scheme for the engine-ID used in the network
requires it. See Configuring the Agent Engine ID.
2. Enable the SNMP agent. See Enabling the SNMP Server.
3. Create views. See Defining SNMP Views.
4. Create groups. See Defining SNMP Groups.
5. Create the users. See Defining an SNMP User.
6. If you need to limit the managed communication for users according to access list
criteria, see Displaying the Named Access Lists
7. The show access-lists command, in Privileged (Enable) mode, displays the defined
named access lists.
Command Syntax
device-name#show access-lists
Example
The following example displays the defined rule for any routing protocol. The access list,
named jiji, permits access from any source. The access list, named phone, permits all
addresses from the range 34.34.34.6/16 that meet an exact match.
device-name(config)#access-list jiji permit any
device-name(config)#access-list phone permit 34.34.34.6/16
device-name#show access-lists
access-list jiji permit any
ccess-list phone permit 34.34.34.6/16
8. Access List to a User.
Assigning an
MN700004 Rev 01 81