Configuration Examples - Nokia ESB26 User Manual

8.
Example
The following example shows how to configure a monitor session to monitor ingress traffic
on multiple source VLANs.
device-name(config)#monitor session rx source vlan 5-10,100
device-name(config)#monitor session rx destination 1/1/3
Displaying Monitor Session Configuration
The show monitor session command, in Privileged (Enable) mode, displays the monitor
session configuration.
Command Syntax
device-name#show monitor session
Example
device-name(config)#monitor session rx destination interface 1/1/8
device-name(config)#monitor session rx source interface 1/1/10-1/1/20
device-name(config)#end
device-name#show monitor session
=================================================
Monitor | Analyzer | Source
---------+----------+---------+------------------
Transmit |
Receive | 1/1/8

Configuration Examples

Configuration Example for Monitor Session on Ports
The following example, based in Figure 8-1, shows how to configure the monitor session on
ports. Interface 1/1/13 mirrors the traffic on interfaces 1/1/1, 1/1/2, 1/1/3, 1/1/4, 1/1/10 and
1/1/12. The traffic is monitored both for Rx and Tx:
device-name(config)#monitor session rx destination interface 1/1/13
device-name(config)#monitor session tx destination interface 1/1/13
device-name(config)#monitor session rx source interface 1/1/1-1/1/4,
1/1/10,1/1/12
device-name(config)#monitor
1/1/3,1/1/10,1/1/12
device-name(config)#end
device-name#show monitor session
=================================================
Monitor | Analyzer | Source
---------+----------+---------+------------------
Transmit| 1/1/13
Receive | 1/1/13
MN700004 Rev 01
Traffic Monitoring
| Monitored Source
| |
| ports | 1/1/10-1/1/20
session
| Monitored Source
| ports | 1/1/1-1/1/4,1/1/10,1/1/12
| ports | 1/1/1-1/1/4,1/1/10,1/1/12
71
tx source interface 1/1/1-