Nokia ESB26 User Manual page 138

13.
rapid-spanning-tree enable/disable
The rapid-spanning-tree enable/disable command, in Protocol Configuration mode,
enables/disables the Rapid-Spanning Tree option.
When RSTP is disabled, you can still use the other commands to set the RSTP configuration.
These settings are preserved when RSTP is enabled.
By default, RSTP is disabled.
Command Syntax
device-name(cfg protocol)#rapid-spanning-tree {enable|disable}
Argument Description
enable
disable
rapid-spanning-tree priority
The rapid-spanning-tree priority command, in Protocol Configuration mode, assigns the
specified value to the RSTP bridge priority. The no form of this command resets the default
value 32768.
If the command is issued without specifying the priority value, it will display the currently
configured priority value.
Command Syntax
device-name(cfg protocol)#rapid-spanning-tree priority <0-65535>
device-name(cfg protocol)#no rapid-spanning-tree priority
Argument Description
0-65535 The rapid spanning tree bridge priority in increments of 4096. Any other number will be
rounded down. The default value is 32768 (IEEE802.1w).
rapid-spanning-tree hello-time
The rapid-spanning-tree hello-time command, in Protocol Configuration mode, sets the
time interval, in seconds, between BPDU transmissions from the ports of this unit. You use
this command when the unit is the root of the Rapid Spanning Tree, or trying to become so.
The default value is 2 seconds and the range depends on the MaxAge value (between 1 and 10
seconds). The no form of this command resets this time interval to its default value.
NOTE
You cannot assign
Command Syntax
device-name(cfg protocol)#rapid-spanning-tree hello-time <hello-time>
device-name(cfg protocol)#no rapid-spanning-tree hello-time
MN700004 Rev 01
Rapid Spanning Tree Protocol (RSTP)
Enable the spanning tree status.
Disable the spanning tree status.
a value greater than
hello-time
127
/2-1.
MaxAge