Nokia ESB26 User Manual page 73

7.
Configuring Switch 3:
On Switch 3, LACP is enabled in active mode on interfaces 1/1/3 and 1/1/4, as an aggregated
link to Switch 1.
1. Enter into Protocol Configuration mode and enable the LACP on switch 3:
Switch3#configure terminal
Switch3(config)#protocol
Switch3(cfg protocol)#link-aggregation lacp enable
Switch3(cfg protocol)#end
2. Display the LACP configuration:
Switch3#show link-aggregation lacp
System ID = 00 a0 12 10 94 c0
System priority = 32768
No LAC ports configured
3. Enable LACP on interfaces 1/1/3 and 1/1/4:
Switch3#configure terminal
Switch3(config)#interface 1/1/3
Switch3(config-if 1/1/3)#link-aggregation lacp
Switch3(config-if 1/1/3)#interface 1/1/4
Switch3(config-if 1/1/4)#link-aggregation lacp
Switch3(config-if 1/1/4)#end
4. Display the LACP configuration:
Switch3#show link-aggregation lacp
System ID = 00 a0 12 10 94 c0
System priority = 32768
=========+========+=======+=========
Port | Mode |
---------+--------+-------+--------+
1/1/3 | active |
1/1/4 | active |
=========+========+=======+=========
After the LACP operation the following results on each switch will be displayed.
Switch 1:
Switch3#show interface link-aggregation
==========+========+=================+=====================
Aggregate |Type
----------+--------+-----------------+--------------------+
AG01 | LACP
AG09 | LACP
==========+========+=================+=====================
Sswitch 2:
Switch2#show interface link-aggregation
==========+========+=================+=====================
Aggregate |Type
MN700004 Rev 01
Link Aggregation Groups (LAGs)
Key | Prty |
5 | 32768 |
5 | 32768 |
| Management Name | Ports
| LACP1 | 1/1/1-1/1/4
| LACP9 | 1/1/5,1/1/6
| Management Name | Ports
62
|
|
|
|