Enabling Mstp - Nokia ESB26 User Manual

14.
Table 14-4 MSTP Configuration Commands
C o m m a n d
mstp
name
revision
abort
apply
mstp hello-time
mstp forward-delay
mstp max-age
mstp max-hops
mstp hold-count

Enabling MSTP

The mstp command, in Protocol Configuration mode, enables the MSTP when the enable
argument is specified, disables the MSTP when the disable argument is specified, and enters
into Protocol MSTP Configuration mode if no argument is specified.
By default, MSTP is disabled.
Command Syntax
device-name(cfg protocol)#mstp [enable|disable]
Argument Description
enable
disable
Example
The following Example displays how to enter into Protocol MSTP Configuration mode:
device-name(cfg protocol)#mstp
device-name(cfg protocol mstp)#
Setting the Configuration Name
The name command, in Protocol MSTP Configuration mode, sets the MST region name. The
no form of this command removes the configured MST region name.
Command Syntax
device-name(cfg protocol mstp)#name NAME
device-name(cfg protocol mstp)#no name
MN700004 Rev 01
Multiple Spanning Tree Protocol (MSTP)
D e s c r i p t i o n
Enables/disables the MSTP, or changes the mode from Protocol
Configuration to Protocol MSTP Configuration mode.
Defines the configuration name
Defines the configuration revision
Exits the configuration without saving the MST configuration map.
Saves the MST configuration map and exits the configuration.
Sets the hello time.
Sets the time for forward delay.
Sets the maximum aging time.
Defines the max hop count.
Sets the MSTP transmit holdcounter.
Enables the MSTP.
Disables the MSTP.
150