Nokia ESB26 User Manual page 309

25. Status Monitoring, Statistics and General Commands
Daytime Protocol. Synchronization will be performed every 10 minutes. Local time is
two hours ahead of the server's time.
device-name(config)#time-server daytime 192.168.0.1 10 2
show time-server
The show time-server command, in Privileged (Enable) mode, displays the timeserver
configuration.
Command Syntax
device-name#show time-server
Example
device-name#show time-server
Current system time MON OCT 13 19:00:25 2003
Timeserver protocol : daytime
Remote server IP
Refresh
Managing the Session Log
The following commands enable you to keep a log of your session.
log cli-console
The log cli-console command, in Global Configuration mode, directs log output (messages
issued by the system) to the CLI console - attached to COM port.
The no form of this command stops log output to the CLI console.
Command Syntax
device-name(config)#log cli-console
device-name(config)#no log cli-console
log telnet-console
The log telnet-console command, in Global Configuration mode, directs log output
(messages issued by the system) to the telnet console - if the user is connected through telnet
client.
The no form of this command stops log output to the telnet console.
MN700004 Rev 01
: 10.2.127.160
: 10 min
298