7.
P a r a m e t e r
LACP port mode
LACP port priority
Configuring and Displaying LAGs
Configuring Static LAGs
To set the static LAG, set the ports participating in the static LAG. See Adding a Port to a
Static Link Aggregation Group.
Table 7-2 lists the static LAG configuration commands.
Table 7-2 Static LAG Configuration Commands
C o m m a n d
link-aggregation static id
Adding a Port to a Static Link Aggregation Group
The link-aggregation static id command, in Interface Configuration mode, adds the
configured interface to the specified static link aggregation group. The no form of the
command removes the configured interface from the static LAG to which it belongs.
By default, static LAG is disabled.
NOTE
The link-aggregation static command replaces the trunk command.
Command Syntax
device-name(config-if UU/SS/PP)#link-aggregation static id <id-number>
device-name(config-if UU/SS/PP)#no link-aggregation
Configuring LACP
To set the LACP, proceed as follows:
1. Enable LACP on the switch. See Enabling/Disabling LACP Globally.
MN700004 Rev 01
Link Aggregation Groups (LAGs)
D e s c r i p t i o n
Sets a user-defined name for a specified static aggregate
specified by the LAG id number.
54
D e f a u l t
V a l u e
Active
32768