Nokia ESB26 User Manual page 137

13.
rapid-spanning-tree defaults
rapid-spanning-tree detect protocols
rapid-spanning-tree point_to_point_mac
Table 13-4 RSTP Debug Commands
C o m m a n d D e s c r i p t i o n
debug rstp Displays the RSTP debug messages as specified by the command argument.
show debug rstp Displays the status of the RSTP debug actions that are currently activated.
RSTP Configuration Commands in Protocol Configuration
Mode
rapid-spanning-tree
The rapid-spanning-tree command, in Protocol Configuration mode, displays the current
RSTP parameter configuration. To display Rapid-Spanning-Tree topology for a specified port
or all ports, use the show rapid-spanning-tree command or the show rapid-spanning-tree
interface command in View or Privileged mode.
Command Syntax
device-name(cfg protocol)#rapid-spanning-tree
Example
device-name(cfg protocol)#rapid-spanning-tree
Rapid spanning tree
ProtocolSpecification
Priority
TimeSinceTopologyChange = 102 (Sec)
TopChanges
DesignatedRoot
RootPort
RootCost
MaxAge
HelloTime
ForwardDelay
BridgeMaxAge
BridgeHelloTime
BridgeForwardDelay
TxHoldCount
MigrationTimer
DetectLineCRCReconfig
MN700004 Rev 01
Rapid Spanning Tree Protocol (RSTP)
Sets the RSTP parameters to their defaults for the
configured interface.
Recalculates the protocol migration state.
Set RSTP port point_to_point_mac.
= enabled
= ieee8021w
= 32768
= 4
= 04096.00:A0:12:00:00:03
= 01/01/03
= 200000
= 20 (Sec)
= 2 (Sec)
= 15 (Sec)
= 20 (Sec)
= 3 (Sec)
= 11 (Sec)
= 3
= 3 (Sec)
= disabled
126