Nokia ESB26 User Manual page 258

20.
PORT-LIST
Example
device-name(config)#ip igmp snooping vlan 1 static 01:00:5e:00:01:29
interface 1/1/1,1/1/4-1/1/8
ip igmp snooping vlan immediate-leave
The ip igmp snooping vlan immediate-leave command, in Global Configuration mode,
enables IGMP Immediate-Leave Processing on the VLAN interface. The no form of this
command disables Immediate-Leave processing.
When you enable IGMP Immediate-Leave processing, the switch immediately removes a port
when it detects an IGMP version 2 leave message on that port. You should use the
Immediate-Leave feature only when there is a single receiver present on every port in the
VLAN.
Command Syntax
device-name(config)#ip igmp snooping vlan <vlan-id> immediate-leave
device-name(config)#no ip igmp snooping vlan <vlan-id> immediate-leave
Argument Description
vlan-id
Example
device-name(config)#ip igmp snooping vlan 1 immediate-leave
ip igmp snooping for-all
The ip igmp snooping for-all command, in Global Configuration mode, enables forwarding
of the entire multicast traffic via the specified port list. By default, forwarding is disabled. To
remove the port list, use the no form of this command.
Command Syntax
device-name(config)#ip igmp snooping for-all PORT-LIST
device-name(config)#no ip igmp snooping for-all PORT-LIST
MN700004 Rev 01
IGMP Snooping
Port list, of the form:
u[[/s[/p]]][-u[[/s[/p]]][,u[[/s[/p]]]]]...
Where u, s and p represent a 1- or 2-digit unit number, slot number and
port number respectively.
You can specify:
u for all ports on unit number u;
u/s for all ports on slot number s on unit u;
u/s/p for port p on slot s on unit u;
a hyphenated range (blank spaces are not allowed);
a list, separated by commas (blank spaces are not allowed).
<1-4094> VLAN id value
247