Nokia ESB26 User Manual page 45

5.
Setting a Name to the Fast Ethernet or Giga Ethernet Port
The name command, in Interface Configuration mode, assigns a name to the Fast Ethernet or
Giga Ethernet port to facilitate switch administration. The no form of the command removes
the port name.
By default, the port has no name.
Command Syntax
device-name(config-if UU/SS/PP)#name NAME
device-name(config-if UU/SS/PP)#no name
Argument Description
NAME String of up to 16 characters which represents the port name. Spaces are not allowed.
Setting Duplex Speed
The duplex-speed command, in Interface Configuration mode, specifies the port speed. You
can set the port duplex mode to full or half duplex for Fast Ethernet and Ethernet ports.
The Giga copper ports have crossover detection. The crossover detection allows the switch
port to automatically detect transmit and receive polarity of the Ethernet cable (e.g. the type
of the cable is irrelevant).
By default, the switch is configured to use auto-negotiation to determine the port speed and
duplex setting for each port, except for the Fast Ethernet Fiber ports that are set to Full-100.
You can manually configure the duplex setting and the speed of 10/100/1000 Mbps ports.
Command Syntax
device-name(config-if UU/SS/PP)#duplex-speed VALUE
Argument Description
VALUE The interface's duplex speed type, restricted to the set of literal values listed in Table 5-3.
Table 5-3 Duplex Speed Argument Values
V a l u e
autonegotiate
half-10
full-10
half-100
full-100
half-1000
full-1000
MN700004 Rev 01
Ethernet Interface Configuration
D e s c r i p t i o n
When this option is selected, the port automatically finds the highest speed
that can be supported on the link.
Half duplex at 10Mbps
Full duplex at 10Mbps
Half duplex at 100Mbps
Full duplex at 100Mbps
Half duplex at 1Gbps
Full duplex at 1Gbps
34