Entering Snmp Settings - Nokia M10 User Manual

5.1.7 SNMP page
SNMP page is used to configure the SNMP-related parameters of
M10. In M10, the SNMP can be used only for writing/reading system
contact information and trap addresses. Trap address is an address to
which a trap is sent in case of an authentication violation.
Figure 5-13

Entering SNMP settings

1. Enter contact information and system location information in the
corresponding fields.
2. Enable/disable authentication traps.
3. Add/delete user communities, if needed.
Enter the name of the new user community into the field.
4. Enter trap destination addresses.
Enter the IP addresses of the hosts to which the traps are sent. Enter
also the community string related to this address.
NTC C33539002SE_A0
SNMP page
Copyright Nokia Telecommunications Oy
DRAFT
Management
5-19