23.
auto
Starts first the primary application and if it fails the second application is
activated. If both applications fail to start, the device enters the Sysloader CLI.
Show Commands
The Show commands, summarized in Table 23-4, can be used to:
•
Display the current configuration settings.
•
Display the saved configuration settings.
The following commands display information regarding the switch configuration settings.
Table 23-4 Show Commands
C o m m a n d
show startup-config
show running-config
show boot-mode
show startup-config
The show startup-config command, in Privileged (Enable) mode, displays the switch
configuration saved to NVRAM (configured information that is saved when the power to the
switch is turned off).
Command Syntax
device-name#show startup-config
Example
device-name#show startup-config
! NVRAM Configuration:
!
! ESB26 Version 3.3.0
!
...
Further information displayed includes the following:
•
IP Address
•
SNMP Server Configuration
•
Web-Server Configuration
•
Protocol Configuration
•
Spanning-tree mode (enable/disable)
•
VLAN Configuration
MN700004 Rev 01
Software Upgrade and Reboot Options
D e s c r i p t i o n
Displays the switch configuration saved to NVRAM.
Displays current run-time information regarding the configuration of the
switch.
The command is equivalent to the write terminal command.
Displays the configured boot mode.
280