Nokia ESB26 User Manual page 127

12.
to the spanning-tree interface all command in Protocol Configuration mode. See also
Displaying Port Spanning-Tree Topology Settings.
Command Syntax
device-name(config-if UU/SS/PP)#spanning-tree all
Example
device-name(config-if 1/1/1)#spanning-tree all
============================================================================
Port |Pri|State|PCost |
--------+---+-----+------+-----------+------------------+------+-----+------
--
01/01/01 128 listn
01/01/17 128 block
01/01/19 128 listn
spanning-tree path-cost
The spanning-tree path-cost command, in Interface Configuration mode, sets the STP port
path-cost for the configured interface. The no form of this command resets the default path-
cost value of 10.
Command Syntax
device-name(config-if UU/SS/PP)#spanning-tree path-cost <1-200000000>
device-name(config-if UU/SS/PP)#no spanning-tree path-cost
Argument Description
<1-200000000> STP path-cost value assigned to the configured interface.
spanning-tree priority
The spanning-tree priority command, in Interface Configuration mode, sets the STP priority
for the configured interface. The no form of this command resets the default priority value of
128.
Command Syntax
device-name(config-if UU/SS/PP)#spanning-tree priority <0-255>
device-name(config-if UU/SS/PP)#no spanning-tree priority
Argument Description
<0-255> STP priority value assigned to the configured interface.
spanning-tree defaults
The spanning-tree defaults command, in Interface Configuration mode, restores the STP
parameters to their defaults for the configured interface.
MN700004 Rev 01
Spanning Tree Protocol (STP)
DCost |Designated bridge |DPrt
19 19 32768.00A012000003 128.01
19 0 32768.000002030405 128.63
19 0 32768.000002030405 128.62
116
|FwrdT|DtctTc
2 Disabled
0 Enabled
2 Enabled