Nokia ESB26 User Manual page 282

22. Transparent LAN Services (TLS)
Example
device-name#show tls jumbo-frame
tls Jumbo frame is on
Configuration Example
Figure 22-2 shows an example of an interface TLS configuration. The configuration for the
PE switches is the same. In this example, the users cannot communicate with each other.
Figure 22-2 TLS Interface Example
1. Enable TLS:
device-name#configure terminal
device-name(config)#tls enable
2. Set the EtherType to 0x7000:
device-name(config)#tls ethertype 7000
3. Set the TLS uplink on interface 1/2/1:
device-name(config)#interface 1/2/1
device-name(config-if 1/2/1)#tls uplink
4. Add the TLS uplink as user in VLAN default (VLAN ID 1). Note that the TLS user is a
member in VLAN 1 by default.
device-name(config)#vlan
device-name(config vlan)#config default
device-name(config-vlan default)#add ports 1/1/1 tagged
device-name(config-vlan default)#end
5. Display the TLS configuration:
device-name#show tls
TLS is enabled
TLS EtherType 0x7000
interface 1/2/1 TLS uplink
MN700004 Rev 01 271