Nokia ESB26 User Manual page 143

13.
If Admin link-type is set to Auto, then the value of Operational link-type is determined in
accordance with the specific procedures defined for the switch entity concerned, as defined in
Admin link-type (auto).
If these procedures determine that the switch entity is connected to a point-to-point
LAN segment, then Operational link-type is set to point-to-point, otherwise it is set to
Shared.
In the absence of a specific definition of how to determine whether the switch is connected to
a point-to-point LAN segment or not, the value of link-type shall be Shared.
point-to-point mac
Command Syntax
device-name(config-if UU/SS/PP)#rapid-spanning-tree link-type {auto|point-
to-point|shared}
device-name(config-if UU/SS/PP)#no rapid-spanning-tree link-type
Argument Description
auto Indicates that the link type status is chosen dynamically according to the link state.
point-to- Indicates that the configured interface is connected to one switch, which runs RSTP.
point In point to point rapid, transition to Forwarding state is allowed in certain cases.
shared Indicates that the interface is not connected to a single switch that is running RSTP.
rapid-spanning-tree path-cost
The rapid-spanning-tree path-cost command, in Interface Configuration mode, sets the
RSTP port path-cost for the configured interface. The no form of this command resets the
default path-cost (see table 13-1).
Command Syntax
device-name(config-if UU/SS/PP)#rapid-spanning-tree path-cost <1-200000000>
MN700004 Rev 01
Rapid Spanning Tree Protocol (RSTP)
132
NOT a point-to-point mac