Nokia ESB26 User Manual page 420

Argument Description
primary Boots the image from the first flash.
secondary Boots the image from the secondary flash.
auto Starts first the primary application and if it fails the second application is activated. If
both applications fail to start, the device enters the Sysloader CLI.
Memory Debug Tools
The table below lists the commands for the memory debug tools.
NOTE Only the Technical Support should use the commands in this section.
Table APPENDIX-9 Sysloader Configuration Commands
C o m m a n d D e s c r i p t i o n
memory Switches from Sysloader mode to Sysloader Memory mode.
copy Copies a block of memory.
display Displays a block of memory.
fill Fills a block of memory with a specified value.
memory
The memory command, in Loader mode, switches from Sysloader mode to Sysloader
Memory mode.
The CLI prompt will change after executing this command.
Command Syntax
device name>memory
Example
device name>memory
device name(memory)#
copy
The copy command, in Sysloader Memory mode, copies a block of memory that is specified
by block-length from the specified source address to the specified destination address.
Command Syntax
device name(memory)#copy <src-addr> <dst-addr> <blk-len>
MN700004 Rev 01
APPENDIX
Loader, Sysloader and Dual Boot
XV