Examples; Configuration Example - Nokia ESB26 User Manual

31.
time-server ntp start
The time-server ntp start command, in Global Configuration mode, starts the NTP-server
polling.
NOTE To end the NTP server polling use the no time-server command in Global Configuration
mode.
Command Syntax
device-name(config)#time-server ntp start <polling-interval> ZONE
Argument Description
polling-interval The synchronization refresh period in minutes, in the range <10-44640> (The
upper limit is equivalent to 31 days).
ZONE Shift of local hour relative to GMT (Positive East, negative West of Greenwich).

Examples

1. The following example:
•
Configures the NTP Client by adding an NTP server without an
authentication mechanism;
• Starts the NTP client with a 10-minute polling-interval, and time zone GMT
+ 3 hours.
device-name(config)#time-server ntp add 192.168.0.2
device-name(config)#time-server ntp start 10 3
2. The following example sets the NTP Client with MD5 authentication:
device-name(config)#time-server ntp add 192.168.0.2
device-name(config)#time-server ntp key add 1 pass
device-name(config)#time-server ntp start 10 3

Configuration Example

The following example demonstrates how the switch uses an NTP server.
1. Add the NTP server:
MN700004 Rev 01
NTP Client Description
347