Garp Timer; Show Garp Timer - Nokia ESB26 User Manual

16.
no gvrp
The no gvrp command, in Protocol Configuration mode, changes the switch's GVRP status to
disable. This command is equivalent to gvrp disable.
Command Syntax
device-name(cfg protocol)#no gvrp

garp timer

The garp timer command, in Protocol Configuration mode, sets the GARP timer values. The
no form of this command resets the specified timer to its default vallue if possible (see the
argument parameter described below). The no form of this command used without
20000>
parameters resets all timers to their default vallues.
Command Syntax
device-name(cfg protocol)#garp timer {leave|leaveall} <300-20000>
device-name(cfg protocol)#garp timer {join} <100-6666>
device-name(cfg protocol)#no garp timer {join|leave|leaveall}
device-name(cfg protocol)#no garp timer
Argument Description
join
leave
leaveall
<300-20000>
<100-6666>
Example
device-name(cfg protocol)#garp timer join 200
GARP Join timer value is 200 milliseconds
device-name(cfg protocol)#

show garp timer

The show garp timer command, in Privileged (Enable) mode, displays the current status of the
GARP timers.
Command Syntax
device-name#show garp timer
MN700004 Rev 01
GARP VLAN Registration Protocol (GVRP)
GARP Join timer.
GARP Leave timer.
GARP LeaveAll timer.
Refresh interval for the specified timer. The leave timer
refresh interval must be equal to or smaller than the
leaveall timer refresh interval. The join timer refresh
interval must be no grater than one-third of the leave timer
refresh intervall.
192
<300-