Nokia ESB26 User Manual page 49

5.
Command Syntax
device-name#show interface [UU/SS/PP]
Argument Description
UU/SS/PP (Optional). Represent the Unit, Slot and Port numbers respectively, each in one or two
decimal digits.
Example 1
The following example displays the settings of all the switch's interfaces:
device-name#show interface
====================================================================
|port |name |type |state|link|duplspeed |flow |backpres|default vlan
+-----+-----+-----+------+--------------+-----+--------+------------
1/1/1 eth
1/1/2 eth
1/1/3 eth
1/1/4 eth
1/1/5 eth
1/1/6 eth
1/1/7 eth
1/1/8 eth
Example 2
The following example displays the settings of a specific interface:
device-name#show interface 1/1/8
Name
Type
EnableState
Link
Duplex speed mode
Duplex speed status
Flow control mode
Flow control status
Backpressure
Broadcast limit
Default VLAN
Port Crossover
Displaying the Interface Statistics
The show interface statistics command, in Privileged (Enable) mode, displays the interface
statistics and packet counters. Table 5-5 describes the counters displayed by the show
interface statistics command and Table 5-6 describes the counters displayed by the show
interface statistics extended command.
NOTE The MaxFrameSize refers to the maximum supported packet size depending on the
configuration (1518 bytes or 6 Kbytes).
Command Syntax
device-name#show interface [UU/SS/PP] statistics [extended]
MN700004 Rev 01
Ethernet Interface Configuration
enable down unknown
enable down unknown
enable down unknown
enable down unknown
enable down unknown
enable down unknown
enable down unknown
enable down unknown
=
= 100BaseTX (L3)
= enable
= up
= autonegotiate
= full-100
= disable
= disable
= disable
= unlimited
= 1
= AUTO MDI/MDIX
38
disable disable
disable disable
disable disable
disable disable
disable disable
disable disable
disable disable
disable disable
0003
0001
0001
0001
0001
0001
0001
0001