Nokia ESB26 User Manual page 331

27.
Command Syntax
device-name(config monitor INDICATOR)#enable
Example
The following example enables port monitoring:
device-name(config)#monitor ports
device-name(config monitor ports)#enable
Disabling Periodic Monitoring for a Specific Indicator
The disable command, in Monitoring Configuration mode, disables the periodic monitoring
for a specific indicator.
For default values, see table
Command Syntax
device-name(config monitor INDICATOR)#disable
Example
This example disables port monitoring:
device-name(config)#monitor ports
device-name(config monitor ports)#disable
Restoring the Default Monitoring Configuration
The default command, in Monitoring Configuration mode, restores the indicator's monitoring
configuration to default settings.
Command Syntax
device-name(config monitor INDICATOR)#default
Setting the Monitoring Time Period
The period command, in Monitoring Configuration mode, sets the time intervals at which the
indicator is polled for its status. The no form of the command resets the period to its default
value.
Table 27-4 lists the default monitoring period values.
Command Syntax
device-name(config monitor INDICATOR)#period {hour|minutes|seconds} <value>
device-name(config monitor INDICATOR)#no period
Argument Description
hour Sets monitoring period in hour unit.
minutes Sets monitoring period in minute unit.
seconds Sets monitoring period in second unit.
value The number of hours, minutes, or seconds between polling instances.
Valid values are <1-24> hours or <1-1440> minutes or <1-86400> seconds.
MN700004 Rev 01
Periodic Monitoring
27-2.
320